Radiopaque Glass Ionomer Luting Cement in Capsule
Chemically cured strontium based glass ionomer cement ideal for basic luting of metal based restorations in the convenient capsule delivery.

INDICATIONS

• Cementation of metal-based inlays, onlays, crowns, bridges and posts
• Cementation of high strength (zirconia based) all ceramic crowns and bridges

CONTRAINDICATIONS

• Pulp capping
• In rare cases the product may cause sensitivity in some people. If any such reactions are experienced, discontinue the use of the product and refer to a physician.

• Bonds in a Wet Field

  • No primer or adhesive is required
  • Simple cementation technique

  Sustained Fluoride Release

  • Cariostatic activity

  Smooth, Creamy Consistency

  • Easy to mix and handle

  Low Film Thickness

  • Restorations' seat is better; has fewer problems

  Strong Direct Bond

  • Non-precious and precious metal to tooth structure

  Superior Marginal Seal

  • Minimizes microleakage
  • Coefficient of thermal expansion is similar to tooth structure

  Low Solubility After Set (.06%)

  • Reduced microleakage
  • Less chance of washouts and sensitivity developing
  • Faster "Snap Set" with more working time

  Strong Bonding, Compressive and Tensile Strengths

  • Greater longevity and restoration integrity

  • TECHNICAL DATA:

    • Powder / Liquid ratio (g/g) :0.33/0.18
    • Mixing time (sec.):10 secs
    • Working time (min., sec.) (at 23 °C) (from start of mixing):2 mins 15secs
    • Final finishing commencing time (after seating the restoration):4 mins 30 secs

    • 1. TOOTH PREPARATION

      a) Prepare tooth in usual manner. For pulp capping, use calcium hydroxide

      b) Clean the prepared teeth with pumice and water

      c) Rinse thoroughly with water. Remove excess moisture by blotting with a cotton pellet or gently blowing with an oil-free air

      DO NOT DESICCATE. Prepared surfaces should appear moist (glistening)

      2. RESTORATION PREPARATION

      Make sure that the restoration is pretreated and handled according to the manufacturer’s instructions

      3. CAPSULE ACTIVATION AND MIXING

      a) Before activation, shake the capsule or tap its side on a hard surface to loosen the powder

      b) To activate the capsule push the plunger until it is flush with the main body

      c) Immediately place the capsule into a GC CAPSULE APPLIER and click the lever once

      The capsule is now activated